Jobban átnézve:

„Some Super I/O chips may also contain sensors. We have to write to
standard I/O ports to probe them. This is usually safe.
Do you want to scan for Super I/O sensors? (YES/no):
Probing for Super-I/O at 0x2e/0x2f
Trying family `ITE’…                                      No
Trying family `National Semiconductor’…                  No
Trying family `SMSC’…                                    No
Trying family `VIA/Winbond/Fintek’…                      No
Probing for Super-I/O at 0x4e/0x4f
Trying family `ITE’…                                      Yes
Found unknown chip with ID 0x8510
Trying family `National Semiconductor’…                  Yes
Found unknown chip with ID 0x8510
Trying family `SMSC’…                                    Yes
Found unknown chip with ID 0x8510
Trying family `VIA/Winbond/Fintek’…                      Yes
Found `Winbond W83687THF Super IO Sensors’
    (but not activated)”

Ez a „Found `Winbond W83687THF Super IO Sensors’ (but not activated)”, .. egy modprobe w83627hf után sem változik a helyzet?

Lehet hogy itt lesz a hiba, http://www.winbond.com/PDF/sheet/w83627hf.pdf

„2. HARDWARE MONITOR
2.1 General Description
The W83627HF can be used to monitor several critical hardware parameters of the system, including
power supply voltages, fan speeds, and temperatures, which are very important for a high-end computer
system to work stable and properly. W83627HF provides both LPC and I2CTM serial bus interface to
access hardware .
An 8-bit analog-to-digital converter (ADC) was built inside W83627HF. The W83627HF can
simultaneously monitor 9 analog voltage inputs, 3 fan tachometer inputs, 3 remote temperature, one
case-open detection signal. The remote temperature sensing can be performed by thermistors, or
2N3904 NPN-type transistors, or directly from IntelTM Deschutes CPU thermal diode output. Also the
W83627HF provides: 2 PWM (pulse width modulation) outputs for the fan speed control; beep tone
output for warning; SMI#(through serial IRQ) , OVT#, GPO# signals for system protection events.”

Szóval elvileg a képessége meg van hozzá.

Hát fordíts egy olyan kernelt, vagy csak fordíts hozzá egy modult.

Device Drivers -> Hardware Monitoring support ->
Hardware Monitoring support
Winbond W83627HF, W83627THF, W83637HF, W83687THF, W83697HF

ha nem lenne benne a kernelben, akkor nem a fenti hibaüzi lenne, hogy
FATAL: Error inserting w83627hf (/lib/modules/2.6.20.1-pomm/kernel/drivers/hwmon/w83627hf.ko): No such device
hanem
FATAL: Module w83627thf not found
Azért ennyire nem fatális, benne van a kernelben…

Bocs ezt elnéztem, esetleg valami paramétert modulbetöltéskor? Esetleg levlistán valahol?
http://lists.lm-sensors.org/pipermail/lm-sensors/2006-July/016858.html

ezzel nem jutottam előrébb…hm, azért köszi