megcsinálnám csak nem megy. fent van a kernel-source de hiába adom meg neki az elérési utat, hibát jelez a nvidia installer. leírná valaki mit tegyek???

Itt az olvasnivaló:

Nvidia Installer HOWTO for SuSE Linux users

  Last Update: Sun Sep 18 17:02:20 CEST 2005

This document describes how to use the new nvidia installer for the
installation of the latest nvidia driver, which is available for your
SuSE Linux system.

NOTE: The nvidia installer does not work as long as a Xserver is still
      running and the nvidia kernel module is still loaded. Therefore
      please boot into runlevel 3 by specifying „3” as kernel boot
      option or switch to runlevel 3 („init 3”) and unload the kernel
      module („rmmod nvidia”) before running the nvidia installer.

3. SuSE Linux 9.3-IA32

It is recommended to use YOU (YaST Online Update) for (re)installation
of the nvidia driver. There are several reasons for this. First, it’s
simple. Second, and this is the most important one, you won’t need to
recompile the nvidia kernel module after a kernel update.

Inside YOU enable „Installable and Installed Patches” for „Show Patch
Category” and select „Download NVIDIA(r) Graphics Driver” from the
patches list (usually at the bottom of the list). Note, that you need
to mark it as „Update” (right mouse click) if you already installed it
before and the driver was uninstalled – for any reason. Proceed as
usual now. After YOU has finished restart your Xserver (i.e. logout
from your Xsession) and you’re fine.

People who aren’t afraid of recompiling the nvidia kernel module or
even reinstalling the nvidia driver each time the kernel has been
updated and want or need to use the latest and greatest nvidia driver
can use the following steps 1-3. The others should use the
instructions above using YOU and skip the steps below.

1) Kernel sources must be installed and configured. Usually this means
installing the ‘kernel-source’, ‘make’ and ‘gcc’ packages with YaST2.
Update it – if not already done – via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-7676.

sh NVIDIA-Linux-x86-1.0-7676-pkg1.run -q

3) Configure X.Org with

sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It’s already
      enabled, when the nvidia driver is running.

köszi a segítséget teljes siker 🙂