Mert hogyan is próbáltad eddig?

igen az bocsesz elgepeltem  🙂
addig juttam el hogy egy ado bejonn az amit windowsba utoljara neztem, viszont annak sincs hangja

Most Gentoo linux van, de volt mar Mandrake 10.0 is probalva.
A problema lenyege roved talan annyi, hogy a tuner nem tud frekvenciat allitani.

Nehany  tovabbi info:

# cat /etc/modules.d/bttv
options bttv card=78

# modprobe bttv
(/var/log/messages-ben megjelenik:)Dec 12 22:43:18 marpad bttv: driver version 0.9.15 loaded
Dec 12 22:43:18 marpad bttv: using 8 buffers with 2080k (520 pages) each for capture
Dec 12 22:43:18 marpad bttv: Bt8xx card found (0).
Dec 12 22:43:18 marpad ACPI: PCI Interrupt 0000:00:09.0[A] -> GSI 17 (level, low) -> IRQ 17
Dec 12 22:43:18 marpad bttv0: Bt878 (rev 17) at 0000:00:09.0, irq: 17, latency: 32, mmio: 0xcfcfe000
Dec 12 22:43:18 marpad bttv0: using: Jetway TV/Capture JW-TV878-FBK, Kworld KW-TV878RF [card=78,insmod option]
Dec 12 22:43:18 marpad bttv0: gpio: en=00000000, out=00000000 in=007fffff [init]
Dec 12 22:43:18 marpad bttv0: using tuner=5
Dec 12 22:43:18 marpad bttv0: i2c: checking for TDA9875 @ 0xb0… not found
Dec 12 22:43:18 marpad bttv0: i2c: checking for TDA7432 @ 0x8a… not found
Dec 12 22:43:18 marpad bttv0: i2c: checking for TDA9887 @ 0x86… not found
Dec 12 22:43:18 marpad tuner 0-0060: chip found @ 0xc0 (bt878 #0 [sw])
Dec 12 22:43:18 marpad tuner 0-0060: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
Dec 12 22:43:18 marpad bttv0: registered device video0
Dec 12 22:43:18 marpad bttv0: registered device vbi0
Dec 12 22:43:18 marpad bttv0: registered device radio0
Dec 12 22:43:18 marpad bttv0: PLL: 28636363 => 35468950 . ok

# v4lctl setchannel R6
(vagy SR1, vagy azt hiszem barmi)
(/var/log/messages-ben)
Dec 12 22:45:30 marpad tuner 0-0060: TV freq (0.00) out of range (44-958)

(bar ha jol emlexem, a multkor meg a 0.00 helyett valami baromi nagy ertekek voltak)

Hm….
Ezek szerint senki nem tudd segiteni nekem 🙁