Azt elfelejtettem írni, hogy

SuSE 7.3 egy CD-s verzióját használom ( NEM LIVE rendesen telepített )

GPHOTO configure menupont select camera / port -nál az otjher-be
meg akarom adni, hogy /dev/ttyUSB0 akkor

Please check the permissions

üzenetet kapok root -ként is.

Köszi a segítséget „beljebb jutottam” a problémába

szóval

modprobe usb-storage

mount /dev/sda1 /mnt/USB
mount: /dev/sda1: unknown device

Milyen névem lehet ?

dmesg usb -tõl kezdõdõ része :

eth0: RealTek RTL-8029 found at 0xe800, IRQ 11, 00:50:BF:17:1C:E9.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
uhci.c: USB UHCI at I/O 0xe000, IRQ 5
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
uhci.c: :USB Universal Host Controller Interface driver
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
parport0: PC-style at 0x378 [PCSPP,TRISTATE]
parport0: cpp_daisy: aa5500ff(00)
parport0: assign_addrs: aa5500ff(00)
parport0: cpp_daisy: aa5500ff(00)
parport0: assign_addrs: aa5500ff(00)
lp0: using parport0 (polling).
eth0: no IPv6 routers present
Switching off penguin.
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.1
PPP BSD Compression module registered
PPP Deflate Compression module registered
hub.c: USB new device connect on bus1/2, assigned device number 2
usb.c: USB device 2 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 2
uhci: host controller halted. very bad
hub.c: USB new device connect on bus1/2, assigned device number 3
usb.c: USB device 3 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 3
hub.c: USB new device connect on bus1/2, assigned device number 4
usb.c: USB device 4 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 4
hub.c: USB new device connect on bus1/2, assigned device number 5
usb.c: USB device 5 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 5
Initializing USB Mass Storage driver…
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
hub.c: USB new device connect on bus1/2, assigned device number 6
usb.c: USB device 6 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 6
hub.c: USB new device connect on bus1/2, assigned device number 7
usb.c: USB device 7 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
usb.c: USB disconnect on device 7
hub.c: USB new device connect on bus1/2, assigned device number 8
usb.c: USB device 8 (vend/prod 0x4a9/0x3073) is not claimed by any active driver.
marduk:/mnt #