Hello Macskajancsi!

Koszi a leirast,de sajnos X egyaltalan nincs. Csak console alol tudok barmit is csinalni.
Ott meg ezt csinaltam vegig:

1. openSUSE 11.0-IA32
It is recommended to use YaST for installation of the NVIDIA
driver. There are several reasons for this. First, it’s
simple. Second, and this is the most important one, you won’t need to
recompile the nvidia kernel module after a kernel update.

Update your Kernel via YOU (YaST Online Update). Use

  YaST -> Software -> Software Repositories -> Add

  Protocol: HTTP
  Server Name: : download.nvidia.com
  Directory on Server: /opensuse/11.0

to add the NVIDIA http server as additional installation source.
Now use

  YaST -> Software -> Software Management

to install the NVIDIA driver. The appropriate NVIDIA packages will be
autoselected, if your card is supported. These are either

  a) x11-video-nvidia + nvidia-gfx-kmp-(kernel_flavor)

or

  b) x11-video-nvidiaG01 + nvidia-gfxG01-kmp-(kernel_flavor)

If no additional packages are autoselected, your card is not supported
by the driver (RPMs) at the moment.

Use „sax2 -r” for X.Org configuration.

People who aren’t afraid of recompiling the nvidia kernel module or
even reinstalling the nvidia driver each time the kernel has been
updated and want or need to use the latest and greatest nvidia driver
can use the following steps 1-3. The others should use the
instructions above using YaST and skip the steps below.

1) Kernel sources must be installed and configured. Usually this means
installing the ‘kernel-source’, ‘make’ and ‘gcc’ packages with YaST2.

2) Use the nvidia installer for 173.14.09.

sh NVIDIA-Linux-x86-173.14.09-pkg1.run -q

3) Configure X.Org with

sax2 -r -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It’s already
      enabled, when the nvidia driver is running.

IMPORTANT: You need to recompile and install the nvidia kernel module
          after each kernel update.

sh NVIDIA-Linux-x86-173.14.09-pkg1.run -K

---

De ugyan az a helyzet…

Udv: Gabor

Hello Simico!

Az tokeletesen jo lenne, de sajnos nincs X 🙁
Amikor az X indulna akkor fekete kepernyo es annyi, de nem fagy le, mert dolgozik a vinyo.

Udv:Gabor

Hello Wait!

Koszonom a segitseget! Mindjart nekiallok ujra az installnak!

Udv: Gabor

Hello Bacsi2!

Ez egy UHU linux 2.1. Most tettem fel egy masik gepre amit szervernek akarok hasznalni.A rendes gepen SuSE van ott mukodik az apache.Szal ugy telepitettem fel ahogy a leirasban volt sorrol sorra, hibat sehol nem irt.

udv: Gabor

Sziasztok!

Feltelepitettem az apache-ot es a php-t.Apache mukodik tokeletesen de a PHP nem akar jo lenni.A telepito szerint kene lennie egy libphp4 v 5.so -nak. Nos egyik filet se talalom. Enelkul meg nem akar mukodni:(
Mar 3x telepitem ujra hiba nelkul feltelepul es megsem jo.
Udv: Gabor